How to install mattress spraying machine?

With the development of automation technology in China, more and more enterprises begin to choose to use automatic mattress spraying machine to replace manual work. But there are still a lot of enterprises do not know enough about this equipment, resulting in users cannot play its original advantages and performance. Therefore, before buying and using automatic mattress spraying machine, it is very necessary to understand its installation and daily maintenance precautions.

l How to install mattress spraying machine?

l What are the specifications for the use of mattress spraying machine?

l What matters needed to noticed when using mattress spraying machine?

How to install mattress spraying machine?

(1) The most important condition for the installation of equipment is a horizontal carrier (ground or special platform). The automatic mattress spraying machine is placed on it, and the fixed seat at the bottom of the automatic mattress spraying machine is adjusted to make the working table of the mattress spraying machine in a horizontal position, and the casters are fixed after adjustment to prevent the equipment from sliding because of inertia in the process of operation.

(2) After the automatic mattress spraying machine is fixed, the power is switched on. The automatic mattress spraying machine sold on the market is basically powered by AC 220V voltage (pay attention to the power supply must have ground wire, otherwise the whole frame of the equipment may have static electricity). Plug the plug into the power supply, open the power switch inside the device, and then select the "file" project on the touch screen, select a system original graph in the file to let the automatic mattress spraying machine do the motion test according to this graph, detect the flexibility of the device to do various actions. (It is important to note that the "allow fire" button on the control screen is not turned on during the test because this button is used to control the system glue feed).

(3) The next step is to connect the gas pipe and the rubber hose. Most of the spraying head control cylinder configured by the automatic mattress spraying machine is a small square cylinder. The air pressure of the cylinder is best between 0.6--0.8 MP(the gas into the cylinder must be pure air after air filtration and oil-water separation, otherwise it is easy to cause glue deterioration, but also easy to rust some hardware of the equipment), and then the rubber hose is connected to the spraying head of the automatic mattress spraying machine, and the work of taking over is basically completed.

What are specifications for the use of mattress spraying machine?

This is one of the most worthy of our attention, then how to regulate the use of mattress spraying machine?

First of all, when using the equipment, we should pay attention to the fact that hard objects should not be directly used to touch the touch screen for convenience, which will directly affect the service life and sensitivity of the touch screen. Secondly, when the equipment is working, it cannot be artificially blocked by external forces to prevent the running track of the spraying head. Finally, pay attention to the distance between the spraying head and the work table cannot be too close or too far to keep in 20cm is the best distance.

What matters needed to noticed when using mattress spraying machine?

(1) Before the operation of mattress spraying machine, check whether there are sundries on the running track and transverse track on both sides. If there are sundries, they must be cleaned up.

(2) Run mattress spraying machine and check that there is dry glue attached to the spraying head of the equipment. If there is, it should also be cleaned, otherwise the effect of the spraying gun will be directly affected and the spraying head will be blocked.

(3) On the day after using mattress spraying machine, it is best to clean the spraying head of the equipment with water or the cleaning solution provided by the equipment supplier, so that no residue can be left on the spraying head. If the equipment is not used for a long time, the glue in the hose should also be cleaned out to ensure that it is smooth when used next time.

(4) Each moving part should be rubbed with anti-rust oil to prevent the rusting of moving parts from affecting the sensitivity of next use.

Foshan YIKAI Machinery CO., Ltd can help you to buy the most suitable mattress spraying machine to meet your demands. Contact us soon!